ACR100F SIMFlash (CCID) Reference Manual Subject to change without prior notice [email protected] www.acs.com.hk Subject to change without prior no
Document Title Here Document Title Here Document Title Here [email protected] www.acs.com.hk Page 10 of 18 ACR100F (CCID) Reference Manual Version 3.00
Document Title Here Document Title Here Document Title Here [email protected] www.acs.com.hk Page 11 of 18 ACR100F (CCID) Reference Manual Version 3.00
Document Title Here Document Title Here Document Title Here [email protected] www.acs.com.hk Page 12 of 18 ACR100F (CCID) Reference Manual Version 3.00
Document Title Here Document Title Here Document Title Here [email protected] www.acs.com.hk Page 13 of 18 ACR100F (CCID) Reference Manual Version 3.00
Document Title Here Document Title Here Document Title Here [email protected] www.acs.com.hk Page 14 of 18 ACR100F (CCID) Reference Manual Version 3.00
Document Title Here Document Title Here Document Title Here [email protected] www.acs.com.hk Page 15 of 18 ACR100F (CCID) Reference Manual Version 3.00
FIRMWARE 10 bytes data for firmware version MAX_C The maximum number of command data bytes. MAX_R The maximum number of data bytes that can be re
Appendix A. Supported Card Types The following table is a list of the card types returned by GET_READER_INFORMATION corresponding with the respectiv
Document Title Here Document Title Here Document Title Here [email protected] www.acs.com.hk Page 18 of 18 ACR100F (CCID) Reference Manual Version 3.00
Table of Contents 1.0. Introduction ...
1.0. Introduction More than just a smart card reader, the ACR100F (CCID) SIMFlash has a built-in flash memory and is designed for both accessing plug
2.0. Features USB combo device – works as smart card reader and mass storage USB 2.0 Hi-Speed interface for flash and USB 1.1 Full-Speed interf
3.0. System Block Diagram .0. System Block Diagram The USB Hub Controller is the communication interface between the PC and the MCU of the smart card
4.0. Power Supply The ACR100F requires a voltage of 5 V DC, 100 mA regulated power supply. It gets the power supply from the PC. 4.1. Status LED Bic
5.0. Smart Card Interface The interface between the ACR100F and the inserted smart card follows the specifications of ISO 7816-3. 5.1. Smart Card Po
6.0. USB Interface The connection of the ACR100F to a computer through a USB port follows a USB Standard. 6.1. Communication Parameters The ACR100F
7.0. Communication Protocol ACR100F interfaces with the host via USB connection. It is a compounded device consisting of two interfaces: Chip Card I
Comments to this Manuals